crossover 10Base-T cable

См. также в других словарях:

• Ethernet crossover cable — Gigabit T568B crossover cable ends An Ethernet crossover cable is a type of Ethernet cable used to connect computing devices together directly. Normal straight through or patch cables were used to connect from a host network interface controller… …   Wikipedia

• Category 6 cable — Category 6 cable, commonly referred to as Cat 6, is a cable standard for Gigabit Ethernet and other network protocols that is backward compatible with the Category 5/5e and Category 3 cable standards. Cat 6 features more stringent specifications… …   Wikipedia

• Ethernet over twisted pair — cable (upper) and 8P8C plug (lower) Ethernet over twisted pair technologies use twisted pair cables for the physical layer of an Ethernet computer network. Other Ethernet cable standards employ coaxial cable or optical fiber. Early versions… …   Wikipedia

• Medium dependent interface — Hub with three MDIX ports and one switchable port circa 1998 A medium dependent interface (MDI) describes the interface (both physical and electrical) in a computer network from a physical layer implementation to the physical medium used to carry …   Wikipedia

• Ethernet — An 8P8C modular connector (often called RJ45) commonly used on cat 5 cables in Ethernet networks Ethernet   …   Wikipedia

• Fast Ethernet — In computer networking, Fast Ethernet is a collective term for a number of Ethernet standards that carry traffic at the nominal rate of 100 Mbit/s, against the original Ethernet speed of 10 Mbit/s. Of the 100 megabit Ethernet standards 100baseTX… …   Wikipedia

• Витая пара — В этой статье не хватает ссылок на источники информации. Информация должна быть проверяема, иначе она может быть поставлена под сомнение и удалена. Вы можете …   Википедия

• Modular connector — This article is about modular connectors. For the registered jack (RJ) wiring standard, see registered jack. Left to right, modular connectors: 8P8C plug, 6P6C plug, 6P4C plug, 4P4C plug, 6P6C jack …   Wikipedia

• Autonegotiation — is an Ethernet procedure by which two connected devices choose common transmission parameters, such as speed, duplex mode, and flow control. In this process, the connected devices first share their capabilities regarding these parameters and then …   Wikipedia

• List of device bit rates — This is a list of device bit rates, or physical layer information rates, net bit rates, useful bit rates, peak bit rates or digital bandwidth capacity, at which digital interfaces of computer peripheral equipment and network devices can… …   Wikipedia

• Auflegestandard — Ethernet Twisted Pair Kabel mit RJ45 Steckern EIA/TIA 568A und EIA/TIA 568B wurden durch die Electronic Industries Alliance (EIA), Telecommunications Industry Association (TIA) und International Telecommunications Union (ITU) definiert als… …   Deutsch Wikipedia